MIL-PRF-0032482(SH)
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements are as specified in the contract or order
(see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel
shall contact the responsible packaging activity to ascertain packaging requirements. Packaging requirements are
maintained by the Inventory Control Point s packaging activities within the Military Service or Defense Agency, or
within the military service s system commands. Packaging data retrieval is available from the managing Military
Department s or Defense Agency s automated packaging files, CD-ROM products, or by contacting the responsible
packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The QAWTDs covered under this specification are intended for internal shipboard use where
watertight boundaries are located, ingress and egress through the bulkhead is required, and the bulkhead is
considered structural. QAWTD assemblies are typically operated (opened and closed) manually hundreds of times a
day.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number, and date of this specification.
b.
Quantity required.
c.
Part or identifying number (PIN) (see 1.3).
d.
CPS latch requirements when required (see 3.4.2).
e.
Security lock requirements when required (see 3.4.3).
f.
Hook and bumper requirements when required (see 3.4.4).
g.
Fixed light assembly requirements when required (see 3.4.5).
h.
Hinge requirement degree of swing (see 3.4.7.1).
i.
Hydrostatic pressure requirements (see 3.6.2).
j.
Packaging requirements (see 5.1).
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products
which are, at the time of award of contract, qualified for inclusion in Qualified Products List QPL No. 0032482
whether or not such products have actually been so listed by that date. The attention of the contractors is called to
these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the
Federal Government tested for qualification in order that they may be eligible to be awarded contracts or orders for
the products covered by this specification. Information pertaining to qualification of products may be obtained from
Commander, Naval Sea Systems Command, ATTN: SEA 05S, 1333 Isaac Hull Avenue, SE, Stop 5160,
Washington Navy Yard DC 20376-5160 or emailed to CommandStandards@navy.mil. An online listing of
products qualified to this specification may be found in the Qualified Products Database (QPD) at
6.4 Technical documentation. The requirements for technical documentation should be considered when this
specification is applied on a contract. Technical documentation, including assembly drawings identifying parts
being used, with dimensions and tolerances required for dimensional examination and installation instructions of a
QAWTD on Navy ships, should be included in the contract for delivery with each order of assemblies. Drawing
types are in accordance with ASME Y14.24 and drawing practices are in accordance with ASME Y14.100.
6.5 Additional watertight testing provisions. NAVSEA reserves the right to witness the tests and/or perform
any of the tests set forth herein where such testing is deemed necessary to assure compliance to prescribed
requirements.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business